3Com 9000 manual ATM Addresses Port, Display User, Addresses at Port

124CHAPTER 6: MANAGING NETWORK INTERFACES

ATM Addresses Port	You can configure the ATM addresses as follows:
Table	Display User Management Entities (UME) ATM Addresses at Port
	Display Static ATM Addresses at Port
	Display De-registered ATM Addresses at Port
	Delete All ATM Addresses at Port
	Add ATM Address to Port
	Delete ATM Address by Member ID
	￿Get ATM Addresses at Port
	Delete All Inactive Addresses
Display User	Display User Management Entities (UME) registered ATM addresses for
Management Entities	specified ports of the CoreBuilder 9000 ATM Enterprise Switch. These
(UME) ATM	ATM addresses were received from end stations or edge devices attached
Addresses at Port	to the port and registered using ILMI in the MIB address table. (For more
	information, see “UNI Address Registration” on page 52 in the
	Operations Guide.)
	Addresses defined through LMA are not displayed.
	For easy reference, each ATM address registered at a port is assigned a
	member ID. The member ID is made up of the port number followed by a
	two-digit number of the form 0n, where 0 corresponds to the first ATM
	address registered. For example, the member ID for the first ATM address
	registered at port 3.1.3 is 31301.
	The member ID is useful for displaying information about calls that are
	associated with the ATM address. For example, the switched virtual
	channels (SVC) are established to the LEC, whose ATM address is
	registered at the port. You can use the member ID to get information for
	the specific port attached to that ATM address.