398CHAPTER 11: CONFIGURING AND MANAGING PNNI

Set Scope Mapping Resets all the parameters of the scope mapping table to their default Table to Defaults values. A change to the scope mapping table parameters takes place

after the next reboot.

Command Actions

Enter menu sequence:

(1) SYS: Platform Configuration

 

(1) SET: Switch setup

 

(9) PNI: PNNI Setup

 

(4) CFP: Configure PNNI

 

(4) ICF: Interface Configuration

 

(5) SMT: Scope Mapping Table

 

Configuration

 

(3) SST: Set Scope Mapping Table

 

to defaults

Enter a parameter at the prompt

Parameter

Format or Range

Confirm reset

y or n

Direct access sequence:

1 1 9 4 4 5 3

Command Result

System action taken:

System message display:

The scope mapping table parameters are reset to their default values as defined in the PNNI specification af-pnni-0080_000.

PNNI Scope Mapping Table is set to default values

Example

Enter: 1 1 9 4 4 5 3

The following prompt is displayed:

Set PNNI Scope Mapping Table to defaults (y/n)

Enter 'y' or 'Y', all other input keeps the old values

Y

The following message is displayed:

PNNI Scope Mapping Table is set to default values

Press ENTER to continue...

Page 398
Image 398
3Com 9000 manual After the next reboot, Following prompt is displayed