54CHAPTER 5: CONFIGURING THE PLATFORM

Set Password to Reset the passwords to their factory default settings for the

Factory Default CoreBuilder 9000 ATM Enterprise Switch. These are, for each type of user: read access, write access, and administer access. For more information on access levels, see the CoreBuilder 9000 ATM Switch Fabric Module Getting Started Guide.

To accept the default password, press Enter.

Command Actions

Enter menu sequence:

(1) SYS: Platform Configuration

 

(1) SET: Switch Setup

 

(1) PAS: Password Setup

 

(4) PAS: Set Password configuration

 

to factory defaults

Enter a parameter at the prompt

Parameter

Format or Range

Confirm reset

y or n

Direct access sequence:

1 1 1 4 [parameters]

Command Result

 

System action taken:

The passwords are reset to their factory default values.

System message display:

Password configuration was set to

 

defaults.

Example

Enter: 1 1 1 4

The following prompt is displayed:

Do you really want to reset config? [y/n]

Enter y to confirm. The following message appears:

Password configuration was set to defaults.

The passwords are reset to their factory values.

Page 54
Image 54
3Com 9000 manual Enter 1 1 1 Following prompt is displayed, Enter y to confirm. The following message appears