3Com 9000 manual 9 4 6 6 parameters

404CHAPTER 11: CONFIGURING AND MANAGING PNNI

Set Max Number of Sets the number of calls that can pass between a specific source and any Routes per Cache destination node that has previously been accessed using the same route.

After this number of calls, the cache will be refreshed. The default number of calls is 40. A change to the number of calls takes place immediately.

Command Actions

Enter menu sequence:	(1) SYS: Platform Configuration
	(1) SET: Switch setup
	(9) PNI: PNNI Setup
	(4) CFP: Configure PNNI
	(6) SCR: Set Route Cache (UBR)
	Configuration
	(6) SMN: Set Max Number of Routes
	per Cache
Enter a parameter at the prompt
Parameter	Format or Range
Num of Calls	1 - 1000
Direct access sequence:	1 1 9 4 6 6 [parameters]

Command Result

System action taken:

System message display:

The number of calls that can pass between a specific source and any destination node using the same route is updated.

Num of calls to refresh the DTL cache

is <n>

Example

Enter: 1 1 9 4 6 6 50

The following message is displayed:

Num of calls to refresh the DTL cache is 50

Press ENTER to continue...