ILMI Setup 117

Update Enable or disable the auto-discovery status for the specified port of the Auto-discovery status CoreBuilder 9000 ATM Enterprise Switch. Auto-discovery determines, by negotiation, the common protocol parameters, ATM interface type and IME type to be used by the ILMI channel. The status can be either enabled

or disabled. For more information about auto-discovery, see “Auto-Discovery” on page 57 in the Operations Guide.

Command Actions

Enter the menu sequence:

(1) SYS: Platform Configuration

 

(1) SET: Switch Setup

 

(8) IME: ILMI Setup

 

(3) AUD: Auto-Discovery Setup

 

(2) SET: Set & Save Auto-Discovery

 

ON/OFF Status

Enter a parameter at the prompt

Parameter

Format or Range

Port ID

<slot.group.port> or 0.0 for all ports

Auto-discovery

0 to disable auto-discovery

enable/disable

1 to enable auto-discovery

Direct access sequence:

1 1 8 2 1 [parameters]

Command Result

 

System action taken:

The auto-discovery status is updated for the selected

 

port immediately and is saved in flash.

System message display:

Auto-Discovery is <ENABLED/DISABLED>.

Example

Enter: 1 1 8 2 1 3.1.2

The following message is displayed:

Auto-Discovery is ENABLED.

Page 117
Image 117
3Com 9000 manual SET Set & Save Auto-Discovery