3Com 9000 manual LRD Set LE Service redundancy, Startup delay, Startup Delay Changed, 600

LAN Emulation Redundancy Setup 223

Update Startup Delay Update the startup delay parameter for LANE redundancy facility in the CoreBuilder 9000 ATM Enterprise Switch. The startup delay is the time elapsed between the switch startup and the startup of the LANE redundancy facility.

To display the current value of the parameter, see “Display LE Service Redundancy” on page 221. This parameter is in the range 1–15 minutes and defaults to 10 minutes. For more information about the startup delay, see “LANE Redundancy Start-up Delay” on page 143 in the Operations Guide.

The startup delay takes effect at the next reboot.

Command Actions

Enter menu sequence:			(1) SYS: Platform config
			(1) SET: Switch setup
			(5) SLE: LE setup
			(4) RDN: LE Service redundancy setup
			(3) LRD: Set LE Service redundancy
			startup delay
Enter a parameter at the prompt
Parameter			Format or Range
Startup Delay			Seconds
			Default is 600 seconds.
Direct access sequence:			1 1 5 4 3 [parameters]
Command Result
System action taken:			The startup delay for the LANE redundancy facility is
			set for the next reboot.
System message display:			Startup Delay Changed.
Example
Enter: 1 1 5	4	3 600

The following message is displayed:

Startup Delay Changed.

The startup delay for the LANE redundancy facility in the

CoreBuilder 9000 ATM Enterprise Switch is set to 600 seconds.