Signaling Setup 173

Update Signaling Update the signaling protocol profile for the selected port. See the Protocol Profile previous section for details. This command causes the new Signaling

Protocol Parameters to be activated in the current session, and the new value is stored in flash. If a new value is not entered and stored in flash, the ATM Enterprise Switch reverts to the previous value of the Signaling Protocol Parameters the next time that it reboots.

Command Actions

Enter the menu sequence:

(1) SYS: Platform configuration

 

 

(1) SET: Switch setup

 

 

(4) SIG: Signaling setup

 

 

(5) SPS: Signaling protocol

 

 

configuration setup

 

 

(2) SPR: Set profile of port

Enter a parameter at the prompt

Parameter

Format or Range

Port number

<slot.group.port>; Enter 0.0 for all ports

Signaling profile

0

for user profile

 

1

for network profile

Direct access sequence:

1

1 4 5 2 [parameters]

Command Result

System action taken: The signaling protocol profile is updated. for the specified port.

System message display: Parameter was successfully set

Example

Enter: 1 1 4 5 2 3.1.2 1

The following message is displayed:

This operation will release all SVC connections!

Are you sure (Y/N)?

Enter Y to confirm, N to cancel.

The following message is displayed:

The profile was set successfully.

The signaling protocol for port 3.1.2 is updated to Network and saved.

Page 173
Image 173
3Com 9000 manual Enter 1 1 4 5 2 3.1.2