3Com 9000 manual Example Enter 1 1, LECS-via-ILMI status of port 3.1.2 is enabled

ILMI Setup 119

Update LEC/LECS Update the LECS-via-ILMI parameter for the specified port in the Communication CoreBuilder 9000 ATM Enterprise Switch. If this parameter is enabled, the

Channel LEC communicates on the channel VPI/VCI = (0/16) with the ILMI MIB. It submits an inquiry to obtain the LECS address. If this parameter is disabled, the LEC connects to the LECS using the well-known address or via the preconfigured LECS address in the LEC.

Command Actions

Enter the menu sequence:	(1) SYS: Platform Configuration
	(1) SET: Switch Setup
	(8) IME: ILMI Setup
	(4) MIB: ILMI MIB View Setup
	(2) SET: Set LECS via ILMI
	ON/OFF Status
Enter a parameter at the prompt
Parameter	Format or Range
Port ID	<slot.group.port>
LECS-via-ILMI	0 to disable LECS-via-ILMI
enable/disable	1 to enable LECS-via-ILMI
Direct access sequence:	1 1 8 3 2 [parameters]
Command Result
System action taken:	The LECS-via-ILMI status is updated for the selected
	port.
System message display:	LECS via ILMI is set to
	<ENABLED/DISABLED>.

Example

Enter: 1 1 8 3 2 3.1.2 1

The following message is displayed:

LECS via ILMI is set to ENABLED.

The LECS-via-ILMI status of port 3.1.2 is enabled.