94CHAPTER 5: CONFIGURING THE PLATFORM

Interface Module slot occupancy information for the 7-slot chassis is displayed as follows:

Slot id

Slot status

Interface card type Interface card status

-------

------------

------------------- ---------------------

1

Occupied

ATM I/F card

Up

2

Free

 

 

Doesn’t exist

3

Free

 

 

Doesn’t exist

4

Free

 

 

Doesn’t exist

5

Occupied ATM I/F card

Up

 

6

Free

 

 

Doesn’t exist

7

Free

 

 

Doesn’t exist

 

 

 

 

 

Interface Card Parameters

Table 15 describes the interface parameters displayed by the command for a specific slot ID.

Table 15 Interface Parameters

Parameter

Description

 

 

Port ID

The port number for each of the module’s ports in the

 

format slot.group.port.

Interface Type

The port interface type (for example, OC3-SC). The type

 

determines the interface, including the type of connector.

Media Type

The type of media used by the port (for example, coaxial

 

cable, multi-mode fiber).

Operational Status

The port may be “up” or “down”, “up & connect” , or

 

“doesn’t exist.”

Port Status

Whether the port has been enabled or disabled by

 

management. Can be either “enabled” or “disabled”. If a

 

port is disabled, the CoreBuilder® 9000 cannot connect to

 

the other side via this port.

Frame Mode

The interface framing mode. Can be SDH or SONET.

Clock Src

This may be normal (Nrm) or Loop timing (Lpt).

Loop Mode

Indicate the loopback state of the ATM interface module

 

port. May be “None”, “Loop Forward” or “Loop Back”.

 

 

Page 94
Image 94
3Com 9000 manual Interface Card Parameters, Interface Parameters