3Com 9000 manual You cannot add an additional PVC destination to a P2P PVC

Create Permanent Virtual Channel (PVC) 157

Add PVC Destination Create an additional destination connection (branch) for an existing point-to-multipointPVC.

You can only create an additional destination if the existing PVC was predefined as a PLM PVC.

Enter the call number of the original PVC setup and the parameters: output port number, VPI/VCI and CLP, with the same permissible values. Default values for Cell Loss Level, Priority, and Cell Loss Priority are used. See Table 23. The same limits as full PVC call setup apply.

You cannot add an additional PVC destination to a P2P PVC.

Command Actions

Enter the menu sequence:	(3) CON: Connections
	(4) S&C: Setup of Connections and ATM
	Addresses
	(1) PVC: PVCs Setup
	(4) CRO: Create out VC in call
Enter a parameter at the prompt
Parameter	Format or Range
Call number	Integer
Output port number	<slot.group.port>
Output port VPI	See “Display PVC VPI/VCI Limits” on page 151 for
	VPI/VCI limits.

Output port VCI

Output port CLP

Direct access sequence:

Command Result

System action taken:

System message display:

See “Display PVC VPI/VCI Limits” on page 151 for VPI/VCI limits.

0for clear

1for set

3 4 1 4 [parameters]

An additional PVC destination with parameters specified is created.

A new output VC was created

with call number: <n>

out connection number: <n>