3Com 9000 manual Default ATM address takes place after the next reboot

Configuring PNNI Nodes 343

Set Default ATM Sets the last six bytes (ESI — End System Identifier) of the ATM address of Address the current node to the default ATM address value. A change to the

default ATM address takes place after the next reboot.

Command Actions

Enter menu sequence:	(1)	SYS: Platform Configuration
	(1) SET: Switch setup
	(9) PNI: PNNI Setup
	(4) CFP: Configure PNNI
		(3) NCF: Node Configuration
		(3) CHR: Characteristics
		(2) ADD: ATM Address
		(2) SDF: Set default ATM Address
Direct access sequence:	1 1	9 4 3 3 2 2

Command Result

System action taken:

System message display:

The default ATM address is displayed.

ESI (6 bytes) of ATM ADDRESS was set to DEFAULT: <default address>

Example

Enter: 1 1 9 4 3 3 2 2

The following message is displayed:

ESI (6 bytes) of ATM ADDRESS was set to DEFAULT: 47.00.00.00.00.00.3C.00.00.00.00.00.00.00.C0.DA.60.27.F6.FF

The last six bytes of the ATM address are set to their default values. In the example, for clarity, the ESI of the ATM address is underlined.