Resetting All Parameters

77

Resetting All

You can reset all parameters or all parameters except IP for the

Parameters

CoreBuilder 9000 ATM Enterprise Switch.

￿Reset All

Reset All Except IP Addresses

Reset All Reset all configuration parameters for the CoreBuilder 9000 ATM Enterprise Switch to their factory default settings.

The new settings become active only after the next reboot.

The standby switch will remain in Suspended mode while the reboot is being performed.

Command Actions

Enter the menu sequence: (1) SYS: Platform Configuration

(2) FLS: Flash setup

(1) RES: Reset Config to Defaults

Direct access sequence: 1 2 1

Command Result

System action taken: All configuration parameters are reset to their factory default values.

System message display: Information is displayed as shown in the example.

Example

Enter: 1 2 1

The following messages are displayed:

The new settings will become active after system reboot.

Note: It is suggested not to leave the system running for a long time after reset to factory defaults as it may become unstable.

Do you really want to reset config? [y/n] y

Reset of all saved configuration was done.

Standby switch will remain in Suspended mode while reboot is performed. This will reset and reboot the device!

Are you sure (Y/N)? y

All configuration parameters are reset to their factory values.

Page 77
Image 77
3Com Resetting All, Parameters, CoreBuilder 9000 ATM Enterprise Switch, Enter 1 2 Following messages are displayed