372 CHAPTER 11: CONFIGURING AND MANAGING PNNI
Set SVCC Called
Integrity Time Sets the SVCC called integrity time. The SVCC called integrity time is the
default value used to initialize the SVCC integrity timer at the node that
accepts a switched virtual circuit at a logical group node originated by a
neighbor node. A change to the SVCC called integrity time takes place
after the next reboot.
Command Actions
Command Result
Example
Enter: 1 1 9 4 3 4 16 30
The following message is displayed:
Default Value is 50 (50 sec), new value is 30
Press ENTER to continue...
Enter menu sequence: (1) SYS: Platform Configuration
(1) SET: Switch setup
(9) PNI: PNNI Setup
(4) CFP: Configure PNNI
(3) NCF: Node Configuration
(4) TIM: Timers
(16) SCD: SVCC Called Integrity
Time
Enter a parameter at the prompt
Parameter Format or Range
integrity time 1 - 60000 seconds
Direct access sequence: 1 1 9 4 3 4 16 [parameters]
System action taken: The SVCC called integrity time is displayed and is
updated to its new value.
System message display: Default value is <x>. New value is <y>