3Com 9000 manual Mpoa Devices, Display Current MPS, Configuration Command Actions

226CHAPTER 9: MANAGING LAN EMULATION

MPOA Devices		The switch allows configuration of MPOA entities: MPS and MPC. The
Configuration		configuration is general so that all MPSs and MPCs that request
		configuration receive the same parameters.
Display Current MPS		Displays all the current settings of the MPS variables.
Configuration		Command Actions
		Enter menu sequence:	(2) LEM: LAN Emulation
			(5) MPA: MPOA Devices Configuration
			(1) MPS: MPOA Server Configuration
			(1) DIS: Display current config
		Direct access sequence:	2 5 1 1
		Command Result
		System action taken:	All the current settings of the MPS variables are
			displayed.
		System message display: Information is displayed as shown in the example
			below.
		Example
		Enter: 2 5 1 1
		The following information is displayed:
MPOA Server Configuration
-------------------------
MPS-p1	keep-alive time:		10	(seconds)
MPS-p2	keep-alive lifetime:		35	(seconds)
MPS-p3	internetwork-layer protocols:		IP
MPS-p4	MPS initial retry time:		5	(seconds)
MPS-p5	MPS retry time maximum:		40	(seconds)
MPS-p6	MPS give up time:		40	(seconds)
MPS-p7	default holding time:		20	(minutes)