96 CHAPTER 5: CONFIGURING THE PLATFORM
Set Port Frame Mode Set the interface mode of the selected port as SDH or SONET and save to
flash memory. You are prompted to specify a port and a mode.
Command Actions
Command Result
CAUTION: When setting the port frame mode on one of the ports of a n
OC-3c or 155 Mbps-over-UTP5 card, all four ports are automatically
updated, even if only one port was selected.
Example
Enter: 1 5 3 5.1.1 0
The following messages are displayed:
The following settings will take place:
Changing port <5.1.1> setting from SONET mode to SDH mode.
Changing port <5.1.2> setting from SONET mode to SDH mode.
Changing port <5.1.3> setting from SONET mode to SDH mode.
Changing port <5.1.4> setting from SONET mode to SDH mode.
Do you really want to do these changes? (Y/N)? y
Enter y to confirm. The following message is displ ayed:
Setting port frame mode has completed successfully.
The selected port(s) are set and saved.
Enter the menu sequence: (1) SYS: Platform Configuration
(5) IFC: Interface Cards
(3) SFM: Set Port Frame Mode
Enter a parameter at the prompt
Parameter Format or Range
Port ID slot.group.port (0.0 - For all)
Frame Mode 0 - SDH
1 - SONET
Direct access sequence: 1 5 3 [parameters]
System action taken: The frame mode of the selected port on the interface
module is set and saved.
System message display: Setting port frame mode has completed
successfully.