3Com 9000 manual 9 4 3 4 1 parameters

Setting the Timers 357

Set PTSE Holddown Sets the PTSE holddown timer value. The PTSE holddown timer value is Timer the value (expressed in milliseconds) used by the specified node to limit

the rate at which it can send PTSEs. A change to the PTSE holddown timer value takes place after the next reboot. For more information on PTSEs, see “PTSE” on page 190 in the Operations Guide.

Command Actions

Enter menu sequence:	(1) SYS: Platform Configuration
	(1) SET: Switch setup
	(9) PNI: PNNI Setup
	(4) CFP: Configure PNNI
	(3) NCF: Node Configuration
	(4) TIM: Timers
	(1) PHD: PTSE Holddown Timer
Enter a parameter at the prompt
Parameter	Format or Range
interval	1 - 30000 milliseconds
Direct access sequence:	1 1 9 4 3 4 1 [parameters]

Command Result

System action taken:

System message display:

The PTSE holddown timer values is displayed and is updated to its new value.

Default value is <x>, new value is <y>

Example

Enter: 1 1 9 4 3 4 1 5

The following message is displayed:

Default Value is 10 (1 sec), new value is 5

Press ENTER to continue...