40 CHAPTER 3: INTEGRATED FAST SETUP
Setup Procedure
Sections Table6 lists the steps or sections of the Integrated Fast Setup.
Entering Data The Integrated Fast Setup procedure runs sequentially through the
relevant data for all of the sections, displaying a prompt for each data
item and a default value. If you want to change the default, enter a
different value in place of the default. If you want to accept the default,
press Enter.
Navigation Aids Table7 lists the shortcut characters that you can use to move between
sections of the Integrated Fast Setup procedure:
Integrated Fast Setup
Operation For step-by-step instructions, see the CoreBuilder 9000 ATM Switch
Fabric Module Getting Started Guide.
Table6 Integrated Fast Setup Procedure Sections
Setup Section Description
1Routing Mode Set the Routing Mode (EIISP or PNNI) for the
CoreBuilder® 9000 ATM Enterprise Switch
2Network Prefix Set Network Prefix for the CoreBuilder 9000 ATM
Enterprise Switch
3PNNI Parameters Set PNNI parameters for the CoreBuilder 9000 ATM
Enterprise Switch
4LE Parameters Set LE parameters for the CoreBuilder 9000 ATM
Enterprise Switch
5LECS Address Set active LECS address for the CoreBuilder 9000 ATM
Enterprise Switch
6UNI/NNI parameters Set UNI/NNI port parameters for ports in the ATM
Interface Module
7IP and Management
Configuration Set IP address of the switch, address of the NMS
application, default gateway address, and subnet mask
8Confirmation Confirm setup operation
Table7 Integrated Fast Setup Procedure Navigation Aids
Type To Go
<Back to previous section
>To next section
>S To section indicated by double underlined ID let ter S in section title
\Back to beginning of setup
$To end of setup