3Com 9000 manual SIG Signaling Setup, VCC VPI/VCI range setup, GET Get VPI/VCI range

Signaling Setup 167

Display VPI/VCI Display the current signaling protocol VPI/VCI configuration parameters Range for a specified port. Maximum and minimum VPI/VCI values are displayed

for each port.

These parameters are set to match the VPI/VCI capabilities of the device attached to the specified port. If an end station or edge device is attached to the port, it frequently has limits on the VPI/VCI channels it can handle; you must set the CoreBuilder 9000 ATM Enterprise Switch port to match these limits.

You can set these parameters independently for each port.

Command Actions

Enter the menu sequence:	(1) SYS: Platform Configuration
	(1) SET: Switch Setup
	(4) SIG: Signaling Setup
	(3) VCC: VPI/VCI range setup
	(1) GET: Get VPI/VCI range
Enter a parameter at the prompt
Parameter	Format or Range
Port number	<slot.group.port> or 0.0 for all ports
Direct access sequence:	1 1 4 3 1 [parameters]
Command Result
System action taken:	The current VPI/VCI Configuration Parameters for the
	specified port are displayed.
System message display:	Information is displayed as shown in the example.