3Com 9000 manual Enter 1 1 4 5 4 3.1.2

176CHAPTER 7: CONFIGURING VIRTUAL CHANNELS

Update Signaling Update the signaling protocol version of the ports of the Protocol Version CoreBuilder 9000 ATM Enterprise Switch and save it to flash.

Command Actions

Enter the menu sequence:	(1) SYS: Platform configuration
	(1) SET: Switch setup
	(4) SIG: Signaling setup
	(5) SPS: Signaling protocol
	configuration setup
	(4) SPV: Set protocol version
Enter a parameter at the prompt
Parameter	Format or Range
Port number	<slot.group.port>; Enter 0.0 for all ports
Protocol version	0 for version 3.0
	1 for version 3.1
	2 for version 4.0
Confirmation	Y or N
Direct access sequence:	1 1 4 5 4 [parameters]
Command Result
System action taken:	The signaling protocol version is updated for the
	specified port.
System message display:	Signaling Protocol Version was
	successfully set.

Example

Enter: 1 1 4 5 4 3.1.2 2

The following prompt is displayed:

This operation will release all connections of the specified port(s)!

Are you sure (Y/N)? Y

Enter Y to confirm, N to cancel.

The following message is displayed:

Signaling Protocol Version was successfully set.

The signaling protocol version for port 3.1.2 is updated to 4.0 and saved.