3Com 9000 manual Database, Command Actions

286CHAPTER 9: MANAGING LAN EMULATION

Update ELAN Update the parameters for the specified ELAN in the LES database. Parameters in LES Table 40 describes the ELAN parameters you can update.

Database

CAUTION: After you use this command to update the parameters of an ELAN in the LES database, you must use the LMA to update the parameters of the ELAN in the LECS database in exactly the same way. (For more information, see “Update ELAN Parameters in LECS Database” on page 251.)

After updating the parameters, the ELAN is reset, that is, the control distribute channel to all LECs that are attached to the ELAN is disconnected.

Command Actions

Enter menu sequence: (2) LEM: LAN Emulation

(2) LES: LE Services

(4) EFP: LES Edit ELANs Parameters

Enter a parameter at the prompt

Parameter Format or Range

ELAN ID

ELAN type

Elan max frame size

Direct access sequence:

Command Result

System action taken:

1–16

For more information, see “Display ELAN Parameters in LES Database” on page 283.

1-Ethernet

2-Token ring

3-VLT

1-1516

2-4544

2 2 4 [parameters]

The parameters for the specified ELAN are updated. The update takes place immediately.

System message display: ELAN is reset.