Setting Interface Parameters 385
Set Aggregation
Tok en Sets the aggregation token. The aggregation token is a number assigned
to an outside link by the border nodes.
This option is currently not supported in this version.
Command Actions
Command Result
Example
Enter: 1 1 9 4 4 2 1 50
The following message is displayed:
Default value is 0, new value is set to 50
Press ENTER to continue...
Enter menu sequence: (1) SYS: Platform Configuration
(1) SET: Switch setup
(9) PNI: PNNI Setup
(4) CFP: Configure PNNI
(4) ICF: Interface Configuration
(2) IPR: Interface Parameters
(1) AGT: Aggregation Token
Enter a parameter at the prompt
Parameter Format or Range
aggregation token 1 - 2147483647
Direct access sequence: 1 1 9 4 4 2 1 [parameters]
System action taken: The aggregation token is updated to its new value.
System message display: Default value is 0, new value is se t to
<n>