3Com 9000 manual Enter 3 4 1 3 p2p 5.1.1 0 37 5.1.2 0

156CHAPTER 7: CONFIGURING VIRTUAL CHANNELS

Create PVC — Quick Set up PVC using the default for parameters not explicitly set. Default Setup values for Cell Loss Level, Priority, and Cell Loss Priority are used. (See

Table 23.) The same limits as full PVC call setup apply. For more information, see “Permanent Virtual Channels” on page 87 in the Operations Guide.

Command Actions

Enter the menu sequence:	(3) CON: Connections
	(4) S&C: Setup of Connections and ATM
	Addresses
	(1) PVC: PVCs Setup
	(3) CRP: Create PVC call
Enter a parameter at the prompt
Parameter	Format or Range
Call type	P2P for point-to-point PVC
	P2M for point-to-multipoint PVC
First port number	<slot.group.port>
First port VPI	See “Display PVC VPI/VCI Limits” on page 151 for
	VPI/VCI limits.
First port VCI	See “Display PVC VPI/VCI Limits” on page 151 for
	VPI/VCI limits.
Second port number	<slot.group.port>
Second port VPI	See “Display PVC VPI/VCI Limits” on page 151 for
	VPI/VCI limits.
Second port VCI	See “Display PVC VPI/VCI Limits” on page 151 for
	VPI/VCI limits.
Direct access sequence:	3 4 1 1 3 [parameters]
Command Result
System action taken:	A PVC with the required parameters is created.
System message display:	A new PVC was created with call number:
	<n>

Example

Enter: 3 4 1 3 p2p 5.1.1 0 37 5.1.2 0 381

The following message is displayed:

A new PVC was created with call number: 9.