3Com 9000 manual 9 4 3 4 6 parameters

362CHAPTER 11: CONFIGURING AND MANAGING PNNI

Set PTSE Lifetime Sets the PTSE lifetime factor value. The PTSE lifetime factor is the value Factor used to calculate the initial lifetime of a PTSE. The PTSE refresh interval is

multiplied by this percentage to obtain the initial lifetime factor. A change to the PTSE lifetime factor value takes place after the next reboot.

Command Actions

Enter menu sequence:	(1) SYS: Platform Configuration
	(1) SET: Switch setup
	(9) PNI: PNNI Setup
	(4) CFP: Configure PNNI
	(3) NCF: Node Configuration
	(4) TIM: Timers
	(6) PLT: PTSE Lifetime Factor
Enter a parameter at the prompt
Parameter	Format or Range
lifetime factor	101% - 1000%
Direct access sequence:	1 1 9 4 3 4 6 [parameters]

Command Result

System action taken:

System message display:

The Hello inactivity factor is displayed and is updated to its new value.

Default value is <x>, new value is <y>

Example

Enter: 1 1 9 4 3 4 6 150

The following message is displayed:

Default Value is 200, new value is 150

Press ENTER to continue...