Compatible Systems HSSI-10/100 manual Shipping Defaults, WAN Interface, Ethernet Interface

Page 16

Chapter 3 - Shipping Defaults

Ethernet Interface

IP Routing Defaults

•On

•Address: 198.41.12.1

•Subnet Mask: 255.255.255.0

•Broadcast Address: 198.41.12.255

•IP RIP off

IPX Routing Defaults

•802.3 on, autoseeding

•802.2 on, autoseeding

•Type II on, nonseeding

•802.2 SNAP on, nonseeding

AppleTalk Routing Defaults

•Phase 1 off

•Phase 2 on, autoseeding

DECnet Defaults

•Off

IP Defaults

•On

•Unnumbered interface

•RIP off

•Van Jacobson compression off

IPX Defaults

•On

•Unnumbered interface

AppleTalk Defaults

•On

•Unnumbered interface

DECnet Defaults

•Off

Link and Physical Defaults

•PPP

•Internal clocking

•16 bit CRC

Image 16

Contents HSSI-10/100 Riop Installation Guide Page Quickstart Configuration Introduction to the HSSI-10/100 Riop Network InstallationTable of Contents Shipping Defaults LED PatternsPage Network Installation Quickstart ConfigurationShipping Defaults Introduction to the HSSI-10/100 RiopNetwork Installation Connecting the HSSI-10/100 to the EthernetConnecting a Management Console Powering Up the RouterQuickstart Configuration Ethernet Interface ConfigurationIP Protocol Required for IPDECnet Protocol AppleTalk ProtocolIPX Protocol Link Configuration WAN Interface ConfigurationIP Protocol AppleTalk Protocol Required for IP Numbered Interface Frame Relay Dlci MappingsRequired for IP Unnumbered Interface AppleTalk Protocol Saving a Configuration File to Flash ROM DECnet ProtocolSmds Addressing Suggested for Dedicated/Leased Line OperationWAN Interface Shipping DefaultsEthernet Interface Router LED Patterns LED PatternsHSSI-10/100 Riop LED Patterns