Chapter 12 Complete Command List
store tcpip tcp opts
Example: store tcpip tcp opts keepalive
Control whether the NIC maintains a connection with a host when data cannot be accepted into its buffer. Normally the keepalive feature is enabled so when the printer cannot accept data, the print job connection is maintained and continued once the situation clears. The keepalivedata option controls whether the keepalive packet contains a data byte for hosts that require it. zeroIPArp is disabled then a NIC with an IP address of 0.0.0.0 will not allow IP access until the IP address is configured. If zeroIPArp is enabled on a NIC with an IP address of 0.0.0.0 then any attempted access with a valid IP address is assumed for this NIC and an Arp lookup is performed.
Default: enabled
store tcpip tcp access [root] adddel <NETWORK> [<NETMASK>]
Example: store tcpip tcp access add 192.75.11.25
Add or remove an entry from the NIC TCP access list defined by <network>. If the list has an entry, only this host can print to and remotely interact with the print server.
store tcpip from defaultcurrent Example: store tcpip from default
Set all TCP/IP network settings back to factory defaults.
Example: store tcpip from current
Store all current TCP/IP network settings to flash memory so they are retained after a power cycle. This ensures all current settings match what is stored in flash memory.
store tn dest <DXPRN> mode 52503270
Example: store tn dest d1prn mode 3270
Store the TN protocol mode.
Default: 5250
232
