Appendix A Unix Troubleshooting Tips
To add/delete a TCP access list entry, refer to “TCP Access Lists” on page 259.
NOTE: When the following procedure is used, the TCP access list will be cleared, but all IP addresses will need to be entered again after the procedure is complete.
To reset all Integrated NIC TCP/IP values to the factory defaults when access is impossible, contact your Printronix service representative for assistance.
If the Web browser access does not work, telnet into the NIC as root. Enter the following command:
config http on
If you are still experiencing difficulty accessing or browsing the printer, contact the Customer Solutions Center for further assistance.
Front Panel Message – Dynamically Set Params Read Only
This is not an error. It is an informational message warning that the IP address has been dynamically set by either dhcp, rarp, or bootp.
To assign a static IP address, turn off the rarp, bootp, and dhcp on the adapter. Use the following procedure:
1.Telnet to the adapter. Login = root, password = (Enter key) Telnet commands are:
store tcpip 1 opts
save
reset
Wait two minutes for the adapter to reset.
2.Program the IP address, Subnet Mask and Gateway (if required) from the front panel.
280
