Black Box EME144A-R2, ServSensor V4E Lite manual Frequently Asked Questions FAQs

Page 73

Chapter 8: Frequently Asked Questions (FAQs)

Figure 8-4. LED patterns in Recovery mode.

LEDs run clockwise after the power is connected.

From left to right, each LED indicates:

1st LED: U-Boot init

2nd LED: Kernel loaded with good CRC

3rd LED: Board init

4th LED: Serial port

5th LED: Ethernet

6th LED: NOR Flash

7th LED: NAND Flash

8th LED: Root file-system mounted. Starting initialization process

EME144A-R2	724-746-5500 blackbox.com	Page 73
EME144A-R2

Image 73

Contents ServSensor V4E Lite Trademarks Used in this Manual Trademarks Used in this ManualFCC and IC RFI Statements NOM Statement Table of Contents Specifications SpecificationsOverview Introduction OverviewWhat’s Included Front Panel Hardware DescriptionBack Panel Installation Setting Up the IP Address InstallationInstallation Testing the New IP Address with the Ping Command MS-DOS window Settings tab Firmware Upgrade10. Firmware Upgrade Rebooting screen Installation 14. Groups Multi-users and Groups Setup Group SetupInstallation 18. User Setup screen User SetupInstallation 21. Properties button Services and Security Active Services Application DisablingClosing or Changing Ports Disabling Http and Enabling Https SNMPv3 SSL Security Feature 25. Select SSL Key screen Active SecuritySetting Up a Sensor NAC or Network Access Control Security FeatureInstallation 30. Sensors Notification Thresholds34. Sensor Offline screen 35. Select Sensor Type screen Advanced Sensor SettingsAdvanced Mode Functions 40. Advanced settings, data collection type Installation Installation Installation 45. Advanced Settings, Check Rate of Change screen 46. Enable Calendar Status screen 47. Enable Calendar screen Using an Internal Mic as a Sound Detection Sensor48. Sound Detector tab Installation 51. Sensors tab, extended port option Expansion PortsInstallation 54. Notification Thresholds Notifications NotificationsAdding a Notification Add an Snmp trap Snmp TrapParameter Selection, screen #1 Notifications tab Select the Snmp parameters 11. E-mail Action Wizard screen Mail12. Input e-mail name and message Notifications Notifications Notifications 21. Snmp Trap and E-mail Notificiations screen SMS NotificationNotifications Notifications 28. Choose board and sensor Notifications Notifications Mapping MappingAdding a Map Enter map name Choose to have the map as a top-level map Mapping Mapping 10. Save changes Monitoring via the Map InterfaceFilters Sensor Filters FiltersSummary Syslog Filters Filters Saved syslog filters display Making the ServSensor Visible on the Internet Making the ServSensor Visible on the InternetFrequently Asked Questions FAQs Frequently Asked Questions FAQsLED patterns in Normal mode LED patterns in Safe mode Frequently Asked Questions FAQs Activate Dhcp Select change password option Change the password Frequently Asked Questions FAQs Frequently Asked Questions FAQs Frequently Asked Questions FAQs Blackbox.com About Black Box Black Box Tech Support FREE! Live /7