SpectraLink SVP100, SVP020, SVP010 manual Rtp

Page 25

SpectraLink Corporation	Installation, Configuration, and Administration
	NetLink SVP Server (within IP environments)

•If any of the Traffic Class settings are set at any value (Value Y) other than Default, that setting (Value Y) will override the Administration setting.

		Administration
Traffic Class		Default	Value X

WT (In call)	Default	4	X
Priority High	Value Y	Y	Y
Priority High


WT (Standby)	Default	0	X
Priority Med	Value Y	Y	Y
	Value Y	Y	Y

RTP	Default	4	X
Priority High	Value Y	Y	Y
	Value Y	Y	Y

PBX	Default	0	X
Priority Med	Value Y	Y	Y
	Value Y	Y	Y

Inter-SVP2	Default	0	X
Priority Med	Value Y	Y	Y
	Value Y	Y	Y

Administration	Default	0	X
Priority Low	Value Y	Y	Y
	Value Y	Y	Y

Note: Default DSCP settings will mark traffic for Best Effort handling under normal circumstances. Please consider changing these values based on the recommended QoS settings from your network hardware manufacturer to achieve prioritization for your voice traffic..

PN: 72-0178-01-F.doc

Page 25

Image 25

Contents NetLink SVP Server Installation, Configuration, and AdministrationSVP100 SVP020 SVP010 For Cisco and Mitel IP environmentsSVP Trademark InformationImportant Safety Information Table of Contents SpectraLink Corporation Model Numbers About This DocumentRelated Documents Customer Support HotlineNetLink SVP Server Overview SpectraLink Voice Priority SVP and Quality of ServiceSVP Server Models Timing FunctionMultiple NetLink SVP Server Capacities Multiple SVP Servers/Master SVP ServerNetLink SVP010 and SVP020 Server Capacity NetLink SVP100 Server CapacitySVP SpectraLink Corporation IP telephony system example System DiagramAdministrative computer Ethernet switchSystem Components RouterTftp Server Link LEDs Front Panel of the NetLink SVP ServerInstall the NetLink SVP Server Installing the NetLink SVP ServerRequired Materials Locate the NetLink SVP ServerMount the NetLink SVP Server to a wall Connect PowerConnect NetLink SVP Server to LAN Connecting to the NetLink SVP Server Configuring the NetLink SVP ServerConnecting Via Telnet Connect via the Serial PortNetLink SVP-II System Menu SendAll Network ConfigurationNetwork administrator must define the subnet mask As set in Wins SVP Server Configuration Phones per Access Point Alias IP Addresses are not necessary in Cisco systems Default value as shown in the table below will be used QoS ConfigurationRTP Change Password Adding an SVP Server Swapping/Adding/Deleting SVP ServersRemoving an SVP Server Changing the Master SVP ServerSoftware Updates Software MaintenanceTroubleshooting via System Status Menu Alarm Text Action Error StatusNetwork Status SpectraLink Corporation Software Version Gatekeeper Database Index