Thecus Technology N8800 user manual Typical Setup Procedure, Management Mode, USB Copy

System Fan2	Current system fan 2 status.
CPU Fan	Current CPU fan status
2006/06/16 12:00	Current system time.
Disk Info	Current status of disk slot has been installedh
RAID	Current RAID status.

The N8800 will rotate these messages every one-two seconds on the LCD display.

USB Copy

The USB Copy function enables you to copy files stored on USB devices such as USB disks and digital cameras to the N8800 with a press of a button. To use USB copy, follow the steps below:

1.Plug your USB device into an available USB port on the Front Panel.

2.In Display Mode, press the Down Button (▼).

3.The LCD will display “USB Copy?”

4.Press Enter (↵) and the N8800 will start copying USB disks connected to the front USB port.

5.All of data will be copied into system folder named “USBcopy”.

Management Mode

During setup and configuration, the LCD will be in Management Mode.

To enter into Management Mode, press Enter (↵) and an “Enter Password” prompt will show on the LCD.

At this time, the administrator has to enter the correct LCD password. System will check whether the correct LCD password has been entered. The default LCD password is “0000”. If correct password is entered, you will enter into the Management Mode menu.

Management Mode

Item	Description
WAN Setting	IP address and netmask of your WAN ports.
LAN Setting	IP address and netmask of your LAN ports.
Link Agg. Setting	Select Load Balance or Failover. (N8800 only)
Change Admin Passwd	Change administrator’s password for LCD operation.
Reset to Default	Reset system to factory defaults.
Exit	Exit Management Mode and return to Display Mode.

NOTE

You can also change your LCD password using the Web Administration Interface by navigating to System > Administrator Password. For more on the Web Administration Interface, see Chapter 4: System Management.

Typical Setup Procedure

From the Web Administration Interface, you can begin to setup your N8800 for use on your network. Setting up the N8800 typically follows the five steps outlined below.

For more on how to use the Web Administration Interface, see Chapter 4: System Management > Web Administration Interface.

18