Step 4: Install Drivers
5.The Windows 2000 Setup screen will appear again saying “Setup will load support for the following mass storage devices:” The list will include “Windows Promise SATAII150/SATA300TX2plus [or TX4] (tm) IDE Controller”.
NOTE: If there are any additional devices to be installed, specify them now. When all devices are specified, continue to the next step.
6.From the Windows 2000 Setup screen, press Enter. Setup will now load all device files and then continue the Windows 2000 installation.
Existing Installation
After installing the SATAII150 or SATA300 Serial ATA Controller card and rebooting your system, Windows 2000 setup will show a “New Hardware Found” dialog box. Under Windows 2000, “PCI Mass Storage Controller” will be displayed.
1.Choose Add New Hardware Wizard from the list, and then press Enter.
2.Choose Add/Troubleshoot a device and click Next. The new hardware wizard will show device list.
3.The screen show a “Welcome to the Found New Hardware Wizard” dialog box. Click Next.
4.Choose Display a list the known drivers for this device so that I can choose a specific driver, then click Next.
5.Select SCSI and RAID controllers, then click Next.
6.When the Windows 2000 supported SCSI adapter drivers list appears, click Have disk.
7.Insert the driver diskette in drive A:\
8.Type A:\ in the text box, then click OK
9.Choose Windows Promise SATAII150/SATA300TX2plus [or TX4]( tm ) IDE controller from the list that appears on screen, then click Next.
10.If using a driver that has not been digitally signed by Microsoft, you will be asked if you want to continue the installation. Click Yes.
11.Click Yes to confirm continue the installation and copy the driver to system.
12.Remove the diskete and click Finish to restart the system. Windows 2000 will then restart for the driver installation to take effect.
13