SATAII150 and SATA300 TX Series Quick Start Guide
Note
If you are using a Promise SuperSwap 1100 or 4100 enclosure in your PC:
•Connect the power cables to the SuperSwap enclosure.
•Attach a SMBus cable from the Management Connector on the SATAII150 TX4 card to the Management Connector on the first enclosure
These actions are described in Chapter 2 of the SuperSwap User Manual.
1.Install the disk drives into the drive bays of your system.
2.Attach the power cables to the disk drives.
3.Attach one Serial ATA data cable to each Serial ATA disk drive. Then attach the other ends of the cables to the connectors on the SATAII150 TX4 card (below).
Individual LED | Aggregate LED | Port 1 / | Port 3 / |
Connectors | Connectors | Channel 1 | Channel 3 |
Management Connector
Port 2 / Channel 2
Port 4 / Channel 4
TX4
ATAII150
SATAII150 TX4
Serial ATA Controller card
6