![](/images/new-backgrounds/1187848/187848111x1.webp)
FastTrak S150 TX4 User Manual
System CMOS Issues
Set Motherboard CMOS Boot sequence to boot to FastTrak S150 TX4
On some Motherboard BIOS, it is necessary to set the Boot sequence to SCSI, A:, C: since the Promise card is identified as a SCSI card.
Motherboard CMOS displays C: or D: drive failure during startup
See the
Using an Onboard IDE Card with FastTrak S150 TX4
If an onboard IDE controller is installed with hard disks, enable support in the Motherboard Standard CMOS Setup for the drives. Note that the onboard IDE hard drives will then be the bootable hard disk unless the system BIOS has a boot sequence setting with the option to specify booting to a different device.
52