Connecting to the Main Power — Install the server near an easily accessible power source. Make sure the power source is the proper voltage for your model. Place the power cord out of the way of traffic; do not place any object over the power cord. Each storage subsystem must have a good electrical ground connection through each power cord, through the building power grid to the point of origin for the building power source entry.
If the server is taken offline for an extended period, disconnect it from the power source to avoid possible damage from a power surge.
Enclosure Openings — Openings in the enclosure ensure proper airflow and prevent overheating; do not cover these openings. Never place liquids on or near the server to avoid spillage; liquid entering an enclosure opening could cause fire or electrical shock.
Earthing — When installing the server in any location (including rack mounting), the installer must validate that the AC input grounding is adequate and that the AC circuit capacity is sufficient and does not create
acircuit overload situation. Reliable earthing of
Circuit
Cleaning the Server — Before cleaning the server, be sure to disconnect all cabling. Do not use any liquid or spray cleaning agents to clean the server; use only a damp sheet or cloth.
Servicing the Server — Never open the Snap Server. For safety reasons, the server should only be opened by qualified service personnel.
Do not attempt a remedy if one of the following situations arises; contact Adaptec technical support for assistance:
• The power cord or plug is damaged.
15 | SANBloc S50 Quick Install Guide |