FieldServer Client Side Connection Descriptors, 9 of 29FS-8700-66GE-SNP Manual, Snp

Page 9 of 29FS-8700-66_GE-SNP Manual Page 9 of 29

4.2.Client Side Connection Descriptors

Section Title
Connections
Column Title	Function	Legal Values
Port	Specify which port the device is	P1-P8, R1-R21
	connected to the FieldServer
Protocol	Specify protocol used	SNP
Baud*	Specify baud rate	110 – 19200, standard baud rates
		only (Vendor limitation), 19200
Parity*	Specify parity	Even, Odd, None, Mark, Space
Data_Bits*	Specify data bits	7, 8
Stop_Bits*	Specify stop bits	1
Handshaking*	Hnadshaking is not supported	None
Poll _Delay*	Time between internal polls	0-32000 seconds, 1 second
	The timeout specified for the connection is used as the data link layer
Timeout	timeout. It is also used as the timeout for each Map Descriptor if a timeout
	is not explicitly defined for a Map Descriptor.
Example

//Client Side Connections

Connections

Port,	Protocol,		Baud,	Parity,	Handshaking,	Poll_Delay
P1,	SNP,		19200,	Odd,	None,	0.100s
GE Port Defaults
		Series 90-30 PLC’s			Series 90-70 PLC’s
Baud		19,200			19,200
Data Bits		8			8
Parity		Odd			Odd
Stop Bits		1			1
Max Link Idle Time		10 Secs			5 Secs
GE Port Capabilities
Baud		300, 600, 1200, 2400, 4800, 9600, 19200
Data Bits		8
Parity		Odd, Even, None
Stop Bits		1, 2
Max Link Idle Time		1 to 60 Secs

1Not all ports shown are necessarily supported by the hardware. Consult the appropriate Instruction manual for details of the ports available on specific hardware.

FieldServer Technologies 1991 Tarob Court Milpitas, California 95035 USA Web:www.fieldServer.com Tel: (408) 262-2299 Fax: (408) 262-2296 Toll_Free: 888-509-1970 email: support@fieldServer.com