Maxtor STM3160813AS Configuring and mounting the drive, Handling and static-discharge precautions

Page 27

3.0Configuring and mounting the drive

This section contains the specifications and instructions for configuring and mounting the drive.

3.1Handling and static-discharge precautions

After unpacking, and before installation, the drive may be exposed to potential handling and electrostatic dis- charge (ESD) hazards. Observe the following standard handling and static-discharge precautions:

Caution:

•Before handling the drive, put on a grounded wrist strap, or ground yourself frequently by touching the metal chassis of a computer that is plugged into a grounded outlet. Wear a grounded wrist strap throughout the entire installation procedure.

•Handle the drive by its edges or frame only.

•The drive is extremely fragile—handle it with care. Do not press down on the drive top cover.

•Always rest the drive on a padded, antistatic surface until you mount it in the computer.

•Do not touch the connector pins or the printed circuit board.

•Do not remove the factory-installed labels from the drive or cover them with additional labels. Removal voids the warranty. Some factory-installed labels contain information needed to service the drive. Other labels are used to seal out dirt and contamination.

DiamondMax 22 Serial ATA Product Manual, Rev. A

21

Image 27

Contents STM31000334AS STM3320614AS STM3160813AS DiamondMax 22 Serial ATARevision Date Sheets affected or comments Rev. a 11/04/08 Initial releaseContents DiamondMax 22 Serial ATA Product Manual, Rev. a Typical 5V startup and operation current profile List of FiguresPage Introduction About the Serial ATA interface Drive specifications Drive specifications summary for 1000 Gbyte models DiamondMax 22 Serial ATA Product Manual, Rev. a Drive specifications summary for 320 and 160 Gbyte models DiamondMax 22 Serial ATA Product Manual, Rev. a Recording and interface technology Default logical geometryLBA mode Formatted capacityPhysical characteristics Seek timeTypical seek times msec Read Write Start/stop times Power specificationsDC power requirements Typical 12V startup and operation current profile Typical 5V startup and operation current profileSleep mode Power-management modesActive mode Idle modeEnvironmental specifications 160 GB models ShockOperating shock Nonoperating shock GB modelsTest for Prominent Discrete Tones PDTs AcousticsElectromagnetic immunity Fluid Dynamic Bearing FDB motor acousticsElectromagnetic compatibility Safety certificationReliability Agency certificationKorean RRL Australian C-Tick N176FCC verification China Restriction of Hazardous Substances RoHS Directive Environmental protection13.2 Corrosive environmentDiamondMax 22 Serial ATA Product Manual, Rev. a Handling and static-discharge precautions Configuring and mounting the driveSerial ATA cables and connectors Configuring the driveDrive mounting Mounting dimensions 1000 GB modelsMounting dimensions 320 and 160 GB models Hot-Plug compatibility Serial ATA Sata interfacePin Function Definition Serial ATA device plug connector pin definitionsSerial ATA connector pin definitions SignalSupported ATA commands Supported ATA commandsCommand name Command code in hex F4H Word Description Value Identify Device commandXx07H Bit Word Description if bit is set to Bit WordWord Set Features command values Set Features command3 S.M.A.R.T. commands M.A.R.T. commandsCode in features register A.R.T. command Technical Support Seagate Technology support servicesInternet Presales SupportWarranty Service Data Recovery Services Authorized Service CentersData Recovery Services Call Center Toll-free Direct dial Index ITE Page DiamondMax 22 Serial ATA Product Manual, Rev. a Page Seagate Technology LLC