Pitney Bowes J641, J640 manual Loading Ribbon and Supplies

Page 15

Chapter 2. Loading Ribbon and Supplies

DO NOT wrinkle or crush the ribbon.

5.With the teeth end of the take-up reel facing down, place the ribbon roll on the spool with the foam washer (on the half of the cassette with the latches).

Take-up

ReelRibbon

Roll

Teeth End of	Spool
Take-up Reel

Foam

Washer

Latch

Gear

Latch

6.Feed the ribbon around the guides and place the take-up reel onto the shorter spool.

7.Twist the ribbon roll back and forth as you firmly push it down until it is seated on the spool.

Do not force the ribbon roll down onto the spool; you could damage the foam washer. Also, make sure the preprinted side of the ribbon faces out. Make sure the latches are still in the unlocked position ( ) before fitting the two halves of the cassette together.

2-5

Image 15

Contents Operators Handbook Canadian D.C.C. Warning Preface Terms to Know Continuous modeTable of Contents J640 Operators Handbook Chapter Power SupplyConnecting the Power Cord Connecting the Communications Cable Communication Values Loading Ribbon and Supplies Pull the label guide forward and down as shown Loading Ribbon Reloading a Ribbon Cassette Loading Ribbon and Supplies Loading Supplies Loading for Peel Mode J640 Operators Handbook Label Guide LED Loading for Non-Peel Mode J640 Operators Handbook Label Guide Upper Opening Rear View Close the printer Printing Printing in On-Demand ModeCanceling a Print Job Printing in Continuous ModeUsing the Tear Bar Interrupting a Print Job Care and Maintenance Clearing Label Jams Cleaning Let the printer dry and reload your supplies LED Indicator TroubleshootingProblem Solution Problems and SolutionsTroubleshooting J640 Operators Handbook Specifications Calling for Service and SuppliesPitney Bowes Supply Numbers Description J640 Operators Handbook