J640 Operator's Handbook
3.Insert the roll of labels between the supply holders inside the printer.
4.Use the handles on the supply holders to press the supply holders together until they fit snuggly against the supply roll.
|
| Supply |
|
|
|
| |
| Supply |
|
|
| Holder |
|
|
| Peel | Spacer |
|
| Bar |
| |
|
|
| |
| Lower | Pinch |
|
| Opening |
| |
| Rollers |
| |
|
|
| |
| Upper | Label |
|
| Opening |
| |
|
| Guide |
|
|
|
|
|
|
|
|
|
Make sure the supply holders are pressed against the supply roll. Also, make sure the supply roll turns freely in the supply well.
5.When using continuous label stock, remove a few inches of labels from the backing paper. Cut away the labels, leaving the backing paper attached to the roll. Be sure the labels have a square, straight edge. Feed the backing paper over the peel bar and through the lower opening of the label guide. Make sure the leading edge of the label is one inch to two inches behind the black platen roller. Otherwise, the ribbon can be pulled out along with the labels, causing a jam.
When loading