Pitney Bowes J640, J641 manual Close the printer

Page 24

J640 Operator's Handbook

7.Close the printer.

Upper

Opening

Label

Guide

Lower

Opening

Make sure the ribbon is wound tightly inside the ribbon cassette before you close the printer. See "Reloading a Ribbon Cassette" to wind the ribbon.

8.Turn the printer on.

9.Wait until the LED flashes one time (about five seconds) and then press the trigger. The printer calibrates the label strip for printing.

Trigger

LED

The LED slowly alternates flashing amber and green to indicate the printer is out of labels. When this happens, load a new roll of labels and change the ribbon. Always change the ribbon when you change label rolls.

2-14

Image 24

Contents Operators Handbook Canadian D.C.C. Warning Preface Continuous mode Terms to KnowTable of Contents J640 Operators Handbook Power Supply ChapterConnecting the Power Cord Connecting the Communications Cable Communication Values Loading Ribbon and Supplies Pull the label guide forward and down as shown Loading Ribbon Reloading a Ribbon Cassette Loading Ribbon and Supplies Loading Supplies Loading for Peel Mode J640 Operators Handbook Label Guide LED Loading for Non-Peel Mode J640 Operators Handbook Label Guide Upper Opening Rear View Close the printer Printing in On-Demand Mode PrintingPrinting in Continuous Mode Canceling a Print JobUsing the Tear Bar Interrupting a Print Job Care and Maintenance Clearing Label Jams Cleaning Let the printer dry and reload your supplies Troubleshooting LED IndicatorProblems and Solutions Problem SolutionTroubleshooting J640 Operators Handbook Specifications Calling for Service and SuppliesPitney Bowes Supply Numbers Description J640 Operators Handbook