Pitney Bowes B700 quick start Important Safety Notes

Page 2

IMPORTANT SAFETY NOTES

Plug the meter into a properly grounded wall outlet. This reduces the risk of shock and equipment damage in the event of a short circuit. DO NOT remove the power cord's ground pin and DO NOT use a ground adapter.

The power cord wall plug is the primary means of disconnecting the meter from the AC supply. The meter is on whenever it is plugged into a live receptacle, even though the key switch and operator display may be off.

Place the meter close to an easily accessible wall outlet. Avoid using wall outlets con- trolled by wall switches or shared by other equipment.

Make sure the area in front of the wall outlet into which the meter is plugged is free from obstruction.

DO NOT route the power cord over sharp edges or trap it between pieces of furniture. Make sure there is no strain on the power cord.

To reduce the risk of fire or electrical shock, DO NOT attempt to remove covers or disassemble the meter. The cabinet encloses hazardous parts. If the meter was dropped or otherwise damaged, report such damage to your Pitney Bowes Customer Service Representative.

Keep fingers, long hair, jewelry and loose clothing away from moving parts at all times.

Read all instructions before you attempt to operate the meter.

Use the equipment only for its intended purpose.

Printhead temperature can reach 103° F (43° C), making it warm to the touch.

Always follow the specific occupational safety and health standards prescribed for your workplace.

Switch the meter OFF when you change the ribbon cassette.

Second Edition, July, 1995

©1995 Pitney Bowes Inc.

All rights reserved. This book may not be reproduced in whole or in part in any fashion or stored in a retrieval system of any type or transmitted by any means, electronically or mechanically, without the express, written permission of Pitney Bowes.

POSTAGE BY PHONE is a registered trademark of Pitney Bowes. PB SUPPLY LINE is a service mark of Pitney Bowes.

Printed on recycled paper

Image 2
Contents Read ME First Important Safety Notes Unpack Shipping Carton and Check Contents Quick Tour of Your New MeterConnect the Power Cord Install the RibbonTab At the Meter Unlock the MeterPut Postage in the Meter At the Phone What You Hear What You DoDirect Distribution Assistance Completing the Refill at Your MeterInstall the Stacker Make a Test ImprintPrinting Postage Place the Quick Refer- ence Guide in the MeterHelp Us Serve You Better Optional FeaturesFor More Information Does the back of your meter look like this? One Elmcroft Road Stamford, Connecticut