Pitney Bowes B700 quick start Install the Stacker, Make a Test Imprint

Page 10

B700 Installation Instructions

6. Install the Stacker

Slide the stacker up against the right side of the meter and posi- tion it as shown. The stacker sits next to the meter. It's not physi- cally connected to it. In this posi- tion, the stacker can handle enve- lopes up to #10. If you're using longer envelopes, move the stacker to the right to accommodate them.

7. Make a Test Imprint

a.The display normally shows the default postage amount

shown at the right. This is usually the rate for first class letter mail weighing up to one ounce.

b.At the keyboard type a 0 (zero) and then Enter.

c.The display now shows zero as the postage value. The

meter is ready to use when the amount you entered is bracketed by three bars as shown.

d.Place a sample envelope on the

feed deck face

 

up and push it

 

against the rear

Insert Envelope

wall of the meter

(1).

from Left

e. Slide the enve-

2

lope to the right

(2) until its lead

1

 

edge touches the

Push Envelope up

trip mark on the

to Mark on Deck

feed deck.

 

f.The meter will sense the pres-

ence of the envelope, convey it through the print area and into the stacker. The meter impression should look similar—but not necessarily identical—to that shown in the figure at the top of the next page.

Page 8

Image 10
Contents Read ME First Important Safety Notes Unpack Shipping Carton and Check Contents Quick Tour of Your New MeterConnect the Power Cord Install the RibbonTab Put Postage in the Meter Unlock the MeterAt the Meter At the Phone What You Hear What You DoDirect Distribution Assistance Completing the Refill at Your MeterInstall the Stacker Make a Test ImprintPrinting Postage Place the Quick Refer- ence Guide in the MeterFor More Information Optional FeaturesHelp Us Serve You Better Does the back of your meter look like this? One Elmcroft Road Stamford, Connecticut