Pitney Bowes B700 quick start Connect the Power Cord, Install the Ribbon

Page 4

B700 Installation Instructions

2.Connect the Power Cord

Remove the meter from its carrying case and place it on your work surface, close to a properly grounded 120 VAC wall outlet. Choose a convenient loca- tion—one where you have enough room to estab- lish an efficient work flow.

a.Connect the power cord to the receptacle at the back of the meter as shown.

b.Connect the power cord to a properly grounded 120 VAC wall outlet.

UL

WARNING: Always plug the

meter into a properly grounded wall outlet. This reduces the risk of shock and equipment damage in the event of a short circuit. DO NOT remove the power cord’s ground pin and DO NOT use a ground adapter. Read the safety notes printed on the inside front cover of this booklet.

3.Install the Ribbon

a.Unpack the ribbon cassette and remove the shipping tab. If nec- essary, turn the winder counter- clockwise to remove any slack from the ribbon.

b.Open the cassette door.

A

B

Page 2

Page 3 Page 5
Image 4
Page 3 Page 5
Contents Read ME First Important Safety Notes Unpack Shipping Carton and Check Contents Quick Tour of Your New MeterConnect the Power Cord Install the RibbonTab Put Postage in the Meter Unlock the MeterAt the Meter At the Phone What You Hear What You DoDirect Distribution Assistance Completing the Refill at Your MeterInstall the Stacker Make a Test ImprintPrinting Postage Place the Quick Refer- ence Guide in the MeterFor More Information Optional FeaturesHelp Us Serve You Better Does the back of your meter look like this? One Elmcroft Road Stamford, Connecticut
Top Page Image Contents