Soehnle CWC7746 Malfunctions Causes and how to eliminate them, Indicator Remedy

Malfunctions - Causes and how to eliminate them

Indicator	Remedy
An acoustic signal confirms
that entry was correct
Incorrect entries are indicated
by 5 acoustic signals in swift
sucession	Check that your entry is
	correct - if necessary interrupt
	the command sequence by
	pressing ”C” or ”CI”.
The scale sets the value zero	Remove the items from the
automatically when it is	weighing platform. Remove
switched on. If the scales are	any dirt. If the scales do not
outside the set tolerance	indicate zero after a couple of
range, -0- is displayed.	seconds, you should contact
	your service partner.
Underloaded: only the	Switch the scales off and on
bottom horizontal lines	again. The zero point will be
appear on the display	reset automatically.
Overload: Only the top	Remove some of the items to
horizontal lines appear on	be weighing from the scales.
the display. The maximum
weighing range has been
exceeded.
Weight of item too light.
The zero setting range has
been exceeded
Taring is not possible in case
of over- or underloaded
balance
Printing is not possible in case
of over- or underloaded
balance.
kg / lb conversion is blocked

Totals memory occupied

-must be cleared before commutation -

In case of all er ror indications:

Please contact your

service- partner.

19