ENGLISH
BED SCALE 7711
6. Error messages
■Error numbers > Cause / Remedy / Info
05Zeroing not possible
> Deviation from zero point too large
06Taring no possible
> Empty scale, scale underloaded or overloaded, manual tare input with tare value above max. load
07 Print not permitted
08No mass unit switchover
09Print signal buffer full
10Load cell signal overflow
11No measuring point signal
12Check sensor position
> Incorrect lever setting for at least one weighing device or no weigh on at least one weighing device (plausibility check active)
13Converter failure
15Measuring point
16No measuring point detected
18Measuring point not zeroed
20Print format empty
23Print error
24Print template memory corrupt
25No print template(s)
26Printer update cancelled
30 Alibi memory full
33Alibi memory contents corrupt
34Alibi memory empty
35No or defective alibi memory
36Cannot write alibi
37Alibi memory unreadable
40General data format error
41Input value too small
42Input value too big
44
50Value below zero range limit
> Zeroing not possible because measured value is outside the set zero range limit
24