Abit IS-11, IS-12, IS-20, IS-10 user manual Floppy and IDE Disk Drive Connectors

Page 23

Hardware Setup	2-15

2.4.11.Floppy and IDE Disk Drive Connectors

The FDC1 connector connects up to two floppy drives with a 34-wire, 2-connector floppy cable. Connect the single end at the longer length of ribbon cable to the FDC1 on the board, the two connectors on the other end to the floppy disk drives connector. Generally you need only one floppy disk drive in your system.

NOTE: The red line on the ribbon cable must be aligned with pin-1 on both the FDC1 port and the floppy connector.

Each of the IDE port connects up to two IDE drives at Ultra ATA/100 mode by one 40-pin, 80-conductor, and 3-connector Ultra ATA/66 ribbon cables.

Connect the single end (blue connector) at the longer length of ribbon cable to the IDE port of this board, the other two ends (gray and black connector) at the shorter length of the ribbon cable to the connectors of your hard drives.

NOTE: Make sure to configure the “Master” and “Slave” relation before connecting two drives by one single ribbon cable. The red line on the ribbon cable must be aligned with pin-1 on both the IDE port and the hard-drive connector.

User’s Manual

Image 23

Contents IS-10/IS-11/IS-12/IS-20 Page Table Of Contents Chapter Chapter Driver InstallationAppendix A. How to Get Technical Support Features & Specifications Miscellaneous Internal I/O ConnectorsExternal I/O Connectors Layout CCMOS1 Jumpers & Connectors DescriptionInstall The Motherboard Hardware SetupInstall Pentium 4 CPU and Heatsink Supporting-Base System Memory Memory Configuration TableInstalling and Removing Memory Modules ATX Power Connectors Connectors, Headers, and SwitchesFAN Power Connectors Cmos Memory Clearing Header AGP Display Card Slot IS-10/IS-11/IS-12 Front Panel Switches & Indicators Connection Headers Front Panel Audio Connection Header Additional USB Port Connection Headers System Management Bus Connection Header Additional IEEE1394 Port Connection Headers IS-12 Internal Audio Source Connectors Floppy and IDE Disk Drive Connectors Serial ATA Connectors CPU Core Voltage Selector AUDIO1 External I/O Panel ConnectorsPress DEL to run setup Bios SetupStandard Cmos Features User’s Manual Chapter Page Hyper-Threading Technology Advanced Bios FeaturesPage Dram Timing Selectable Advanced Chipset FeaturesPage Onboard IDE Device Integrated PeripheralsPage SATA1 SATA2 Onboard PCI Device SuperIO Device Page Chapter Power Management Setup Chapter Force Update Escd PnP/PCI ConfigurationsChapter PC Health Status Set User Password Load Fail-Safe DefaultsLoad Optimized Defaults Set Supervisor PasswordDriver Installation Setup Items Appendix A. How to Get Technical Support Appendix a Ireland North America and South AmericaAbit Computer Corporation JapanShanghai Russia France, Italy, Spain, Portugal, and GreeceThank You Abit Computer Corporation Technical Support Form