Abit IP-95 manual Installing Hardware, CPU Socket

Page 14

1.7 Installing Hardware

DO NOT scratch the motherboard when installing hardware. An accidentally scratch of a tiny surface-mount component may seriously damage the motherboard.

In order to protect the contact pins, please pay attention to these notices:

1.A maximum 20 cycles of CPU installation is recommended.

2.Never touch the contact pins with fingers or any object.

3.Always put on the cap when the CPU is not in use.

1.7.1 CPU Socket 775

The installation procedures vary with different types of CPU fan-and-heatsink assembly. The one shown here is served for demo only. For detailed information on how to install the one you bought, refer to its installation guidelines.

1. Place the board so as to let the lever-hook of the socket is on your left side. Use your left thumb and forefinger to hold the lever hook, pull it away from the retention tab. Rotate the lever to fully open position.

3.Use your right thumb and forefinger to grasp the CPU package. Be sure to grasp on the edge of the substrate, and face the Pin-1 indicator toward the bottom-left side. Aim at the socket and place the CPU package vertical down into the socket.

2.Use your right-thumb to raise the load plate. Lift it up to fully open position.

4.Visually inspect if the CPU is seated well into the socket. The alignment key must be located in the notch of package.

1-10

IP-95

Image 14
Contents Motherboard Socket Intel Core 2 Duo Intel Pentium D Intel Celeron DIP-95 Contents IP-95 Specifications Hardware SetupMotherboard Layout Installing Motherboard Choosing a Computer ChassisChecking Jumper Settings Cmos Memory Clearing Header and Backup BatteryHardware Setup Connecting Chassis Components ATX Power ConnectorsFront Panel Switches & Indicators Headers FAN Power Connectors Chassis Speaker Connector Installing Hardware CPU SocketHardware Setup 2 DDR2/DDR Memory Slots Connecting Peripheral Devices Floppy and IDE Disk Drive ConnectorsSerial ATA Connectors Internal Audio Connectors Additional USB 2.0 Port HeadersFront Panel Audio Connection Header PCI and PCI Express X16, X1 Slots Connecting Rear Panel I/O Devices AUDIO1Bios Setup Bios SetupIP-95 Driver & Utility Driver & UtilityIP-95 Multilingual Quick Installation Guide Multilingual QIG2 快速安裝指南 安裝記憶體模組 IP-95 简体中文 2 快速安装指南 安装内存模块 IP-95 1 Q & a Troubleshooting How to Get Technical Support?Appendix Page Appendix Technical Support Form Contact Information Sales sales@abit.com.tw Marketing market@abit.com.twRev