Intermate LX T-04 manual Configuration from a Terminal, Configuration from the System

C o n f i g u r a t i o n

3. Configuration

Although the Intermate LX T-04 is prepared for operation at delivery, you may want to change the configuration. A test printout verifies the current configuration, see Section 2.

The configuration￿ can be done in two ways:

Configuration from a Terminal

This is the method described in this section. The configuration method requires a dedicated IBM 5250 terminal such as a 3180,

￿3179, 3197, 347x or 348x.

Configuration from the System

The Intermate LX T-04 can also be configured using downloaded programming sequences from the system, see Section 4.

Configuration from a Terminal

The Intermate LX T-04 is equipped with a menu-driven Configuration Utility. This provides a step-by-step method to adapt the Intermate LX T-04 to your IBM host and printer. Follow these steps to start the configuration:

1.Switch off the printer.

2.Connect a terminal to the Intermate LX T-04 using the T-cable, and switch the terminal on. The terminal should be terminated.

3.Set the address switch in position '7' and switch on the printer. Wait a few seconds after the SYSTEM indicator has stopped flashing.

4.Select position '9'. Wait until the SYSTEM indicator starts to flash.

5.Select position '7' again.

Within a few seconds, the Key Definitions Menu should appear on your

I n t e r m a t e L X T - 0 4 17