Intermate LX T-04 manual Define the Sequences, Redefine the Sequences

A d v a n c e d F u n c t i o n s

Define the Sequences

The parameters are defined when Extended Emulation Mode is entered.

Example:

Enter Extended Emulation Mode and set the Transparency Lead-In Sequence to '%%', the Configuration Lead-In Sequence to '%P' and the Trailer Sequence to '%':

&&??%%P (Enter Extended Emulation Mode and set parameters)

Redefine the Sequences

The parameters can be redefined using text sequences in the document.

Example:

Change the Transparency Lead-In Sequence from '%%' to '!?<' (EBCDIC codes $4F,$6F,$4C).Also, change the Trailer Sequence from '%' to '>&' (EBCDIC codes $6E,$50):

%P	(Configuration lead-in sequence)
=41,$4F,$6F,$4C	(New Transparency Lead-In)
=43,$6E,$50	(New Transparency Lead-Out)
=205	(Save settings permanently)
>&	(Initialize settings)

Note: - To redefine the sequences, Extended Emulation Mode must be entered. The sequences are reset if you exit and re-enter Extended Emulation Mode. See above.

-The sequences are redefined immediately. Therefore, the new sequence '>&' must be used as Configuration Trailer Sequence in the document.

30 U s e r ‘ s G u i d e