Infinity WZR-G300N user manual Connecting to a Preexisting Network, Auto to BRI

Page 58

Connecting to a Preexisting Network

Add an AirStation without changing your existing LAN configuration

1.Set the AirStation into Access Point Mode by moving the switch on the bottom from

AUTO to BRI.

2.Connect one of the AirStation’s LAN ports to an existing router or switch on your network. Nothing should be plugged into the WAN port.

3.Open LAN Settings - LAN Port Settings and configure the following settings:

IP Address =[192.168.11.1] (Specify an unused network address from the existing

LAN.)

Subnet Mask=[255.255.255.0] (Use the same Subnet Mask as the existing LAN.) DHCP Server Function=[Disable]

4.Restart PC.

58

Image 58
Contents Nfiniti Wireless Router & AP Table of Contents Table of Contents Connecting to an Existing Network Introduction System RequirementsBasic Setup Getting Ready Connecting your AirStation Log in to the Configuration Tool Detecting Your Broadband Connection Home Aoss Aoss Notes Some things to keep in mind with AossRouter/Access Point Mode Manual Client Configuration System Info AirStation Configuration Tool Home Internet Games Port Mapping Firewall/Intrusion Detector Windows MSN Messinger/UPnP Wireless Encryption Wireless Channel Firmware Update Internet Connection Multisession Reset Advanced Settings WAN Config WAN Port PPPoE LAN Config LAN Port Advanced Dhcp Settings Dhcp Server Manual Assignment of IP Address Network Config Route Info Network Configuration Edit Routing Information NAT NAT Manual Entry IP Filter IP Filter Add/Delete Basic Rules IP Filter Configure IP Filter Network Configuration Intrusion Detector UPnP Aoss 802.11g / Draft-N Basic 802.11g / Draft-N Basic 802.11g / Draft-N Security Bridge/Repeater WDS Bridging MAC Access Limit MAC Access Limit Edit Registration List Advanced SettingsAdmin Configuration Name/Password Admin Config Date/NTP Syslog Transfer Save/Load Configuration Initialize/Reboot Firmware Update System Information Log Information Packet Traffic Information Client Monitor Ping Test Connecting to a Preexisting Network Auto to BRISpecifications WZR-G300N AirStation SpecificationsRegulatory Information AirStation Ieee 802.11 Channel Sets Troubleshooting Common ProblemsDiag LED Activity Table Other Problems Configuring a WDS Bridge Here’s the whole setup, ready for initial configuration Configuring a WDS Bridge Configuring a WDS Bridge Configuring a WDS Bridge Configuring a WDS Bridge Configuring a WDS Bridge Configuring a WDS Bridge Configuring a WDS Bridge Configuring a WDS Bridge Troubleshooting WDS Troubleshooting WDS Glossary Glossary Glossary To hardware that requires further manual configuration Glossary Glossary Glossary FCC / CE Information FCC WarningPotential restrictive use Warranty Information Contact Information General InquiriesEmail sales@buffalo-technology.com GPL Information North America GPL Information Europe 125/270* High Speed Mode