Infinity WZR-G300N user manual Configuring a WDS Bridge

Page 69

Configuring a WDS Bridge

On the left-side menu, click on Wireless Config, and then Repeater.

Repeater-Bridge (WDS) must be set to Enable. If it is not, change it to Enable in the drop down menu and click Apply. After the AirStation reboots, the screen will refresh. Click Edit Registered WDS Partners.

Under Add New WDS Partner Access Point, enter the wireless MAC address of the second AirStation, the one that you want to form a bridge with. You can get this from the bottom of the second AirStation (see above). Enter it with each pair of digits separated by a colon, e.g. 000D0B10F778 would be entered “00:0D:0B:10:F7:78”. Press New Partner when done. The AirStation will reboot, and when the screen refreshes, the second AirStation’s MAC address will be listed under Bridgeable Access Points.

69

Image 69

Contents Nfiniti Wireless Router & AP Table of Contents Table of Contents Connecting to an Existing Network System Requirements IntroductionBasic Setup Getting Ready Connecting your AirStation Log in to the Configuration Tool Detecting Your Broadband Connection Home Aoss Some things to keep in mind with Aoss Aoss NotesRouter/Access Point Mode Manual Client Configuration System Info AirStation Configuration Tool Home Internet Games Port Mapping Firewall/Intrusion Detector Windows MSN Messinger/UPnP Wireless Encryption Wireless Channel Firmware Update Internet Connection Multisession Reset Advanced Settings WAN Config WAN Port PPPoE LAN Config LAN Port Advanced Dhcp Settings Dhcp Server Manual Assignment of IP Address Network Config Route Info Network Configuration Edit Routing Information NAT NAT Manual Entry IP Filter IP Filter Add/Delete Basic Rules IP Filter Configure IP Filter Network Configuration Intrusion Detector UPnP Aoss 802.11g / Draft-N Basic 802.11g / Draft-N Basic 802.11g / Draft-N Security Bridge/Repeater WDS Bridging MAC Access Limit Advanced Settings MAC Access Limit Edit Registration ListAdmin Configuration Name/Password Admin Config Date/NTP Syslog Transfer Save/Load Configuration Initialize/Reboot Firmware Update System Information Log Information Packet Traffic Information Client Monitor Ping Test Auto to BRI Connecting to a Preexisting NetworkWZR-G300N AirStation Specifications SpecificationsRegulatory Information AirStation Ieee 802.11 Channel Sets Common Problems TroubleshootingDiag LED Activity Table Other Problems Configuring a WDS Bridge Here’s the whole setup, ready for initial configuration Configuring a WDS Bridge Configuring a WDS Bridge Configuring a WDS Bridge Configuring a WDS Bridge Configuring a WDS Bridge Configuring a WDS Bridge Configuring a WDS Bridge Configuring a WDS Bridge Troubleshooting WDS Troubleshooting WDS Glossary Glossary Glossary To hardware that requires further manual configuration Glossary Glossary Glossary FCC Warning FCC / CE InformationPotential restrictive use Warranty Information General Inquiries Contact InformationEmail sales@buffalo-technology.com GPL Information North America GPL Information Europe 125/270* High Speed Mode