Infinity WZR-G300N user manual Connecting your AirStation

Page 8

Connecting your AirStation

1.Power down the Cable or DSL modem and the computer which will be used to configure the AirStation router.

2.Plug the Cable or DSL’s LAN Ethernet cable into the AirStation’s WAN port. Initially, you may need to unplug this cable from your computer, hub or other router.

3.Plug the provided Ethernet cable into a LAN port on the AirStation and plug the other end into your computer’s Ethernet adapter (NIC). If you plan to initially configure the AirStation wirelessly (not recommended), you may skip this step.

4.Power on your cable or DSL modem and wait one full minute, then power on the AirStation router and wait one full minute, and finally power on the computer which will be used to configure the AirStation. If the red DIAG light on the AirStation is lit or flashing after several minutes of being powered on, please consult Buffalo Technology Technical Support.

Image 8

Contents Nfiniti Wireless Router & AP Table of Contents Table of Contents Connecting to an Existing Network Introduction System RequirementsBasic Setup Getting Ready Connecting your AirStation Log in to the Configuration Tool Detecting Your Broadband Connection Home Aoss Aoss Notes Some things to keep in mind with AossRouter/Access Point Mode Manual Client Configuration System Info AirStation Configuration Tool Home Internet Games Port Mapping Firewall/Intrusion Detector Windows MSN Messinger/UPnP Wireless Encryption Wireless Channel Firmware Update Internet Connection Multisession Reset Advanced Settings WAN Config WAN Port PPPoE LAN Config LAN Port Advanced Dhcp Settings Dhcp Server Manual Assignment of IP Address Network Config Route Info Network Configuration Edit Routing Information NAT NAT Manual Entry IP Filter IP Filter Add/Delete Basic Rules IP Filter Configure IP Filter Network Configuration Intrusion Detector UPnP Aoss 802.11g / Draft-N Basic 802.11g / Draft-N Basic 802.11g / Draft-N Security Bridge/Repeater WDS Bridging MAC Access Limit MAC Access Limit Edit Registration List Advanced SettingsAdmin Configuration Name/Password Admin Config Date/NTP Syslog Transfer Save/Load Configuration Initialize/Reboot Firmware Update System Information Log Information Packet Traffic Information Client Monitor Ping Test Connecting to a Preexisting Network Auto to BRISpecifications WZR-G300N AirStation SpecificationsRegulatory Information AirStation Ieee 802.11 Channel Sets Troubleshooting Common ProblemsDiag LED Activity Table Other Problems Configuring a WDS Bridge Here’s the whole setup, ready for initial configuration Configuring a WDS Bridge Configuring a WDS Bridge Configuring a WDS Bridge Configuring a WDS Bridge Configuring a WDS Bridge Configuring a WDS Bridge Configuring a WDS Bridge Configuring a WDS Bridge Troubleshooting WDS Troubleshooting WDS Glossary Glossary Glossary To hardware that requires further manual configuration Glossary Glossary Glossary FCC / CE Information FCC WarningPotential restrictive use Warranty Information Contact Information General InquiriesEmail sales@buffalo-technology.com GPL Information North America GPL Information Europe 125/270* High Speed Mode